[. . . ] 3 Checking before use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Checking the name of the parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Basic function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Adjusting the air flow direction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Then, pull the Air filter towards you and slide it down.
Air filter
Cleaning the air filter
Washable foam based air filter captures large particles from the air. The filter is cleaned with a vacuum or by hand washing.
Open the panel and put the Air filter out.
Clean the Air filter with a vacuum cleaner or soft brush. If dust is too heavy, rinse it with running water.
Insert the Air filter back in its original position and close the front panel.
Dry the Air filter in a ventilated area.
• Clean the Air filter every 2 weeks. Cleaning term may differ depending on the usage and environmental conditions. • If the Air filter dries in a confined (or humid) area, odors may generate. If it occurs, re-clean and dry it in a well-ventilated area.
20
Australia_AQV30T@_IB&IM_33367A_E. indd 20 2012-6-29 9:20:02
Maintaining the air conditioner
If the air conditioner will not be used for an extended period of time, dry the air conditioner to maintain it in best condition. 1. Dry the air conditioner thoroughly by operating in Fan mode for 3 to 4 hours and cut-off the power supply. 2. Before using the air conditioner again, dry the inner components of the air conditioner again by running in Fan mode for 3 to 4 hours. This helps remove odors which may have generated from dampness.
Periodical checks
Refer to the following chart to maintain the air conditioner properly. Type Description Clean the Full HD filter (1) Indoor unit Clean the condensate drain pan (2) Thoroughly clean the heat exchanger (2) Clean the condensate drain pipe (2) Replace the remote controller batteries (1) Clean the heat exchanger on the outside of the unit (2) Clean the heat exchanger on the inside of the unit (2) Clean the electric components with jets of air (2) Outdoor unit Verify that all the electric components are firmly tightened (2) Clean the fan (2) Verify that all the fan assembly is firmly tightened (2) Clean the condensate drain pan (2)
Every 2 weeks
Every 3 months
Every 4 months
Once a year
: This check mark requires checking the indoor/outdoor unit periodically.
Follow the description to maintain the air conditioner properly. (1) The described operations should be performed more frequently if the area of installation is very dusty. • Check if you press the Set button on the remote controller after you have set the time. • Press the Power button or disconnect the power plug/switch off the auxiliary power switch. Ventilate the room or operate the air conditioner in Fan mode for 1~2 hours. (We do not use smelly components in the air conditioner. )
Timer function does not set. Odors permeate in the room during operation.
22
Australia_AQV30T@_IB&IM_33367A_E. indd 22 2012-6-29 9:20:03
PROBLEM Error is indicated. Indoor unit display indicates “ "
SOLUTION • When an indoor unit indicator blinks, contact the nearest service center. • Depending on the status of the air conditioner usage, noise can be heard when refrigerant flow movement changes. • If may not be a fire but it can be a steam generated by the defrost operation from outdoor heat exchanger during Heat mode in winter. If the air conditioner receives a Demand Response signal from the power supply utility, then the compressor and fans will stop. The indoor unit display will indicate " ".
23
Australia_AQV30T@_IB&IM_33367A_E. indd 23 2012-6-29 9:20:03
INSTALLATION PARTS
※ n this manual, you may find model names written in simplified forms as indicated in following table. I
Model Names AQVT 24 30
Included Models AQV24T, AQV30T AQV24T AQV30T
Remark Grouping was done by series. [. . . ] 1. To minimise condensation problems, wrap foam insulation (as shown in the figure) on a part without insulation on the end of the pipes. 3. Place the bundle (the pipe, assembly cable and drain hose) in the lower part of the indoor unit carefully so it does not project from the rear of the indoor unit. 4. Hook the indoor unit to the installation plate and move the unit to the right and left until it is securely in place. • Make sure pipe does not move when you install the indoor unit on an installation plate. [. . . ]